熱門關鍵詞：濟南彩鋼板 | 濟南復合板 | 濟南彩鋼瓦 | 濟南c型鋼 | 濟南鋼結構 |
How to control the thick wall quality of C-section steel? Different users have different requirements for the thickness of C-section steel. If we want to meet these requirements at the same time, the selected C-beam production process and equipment is very pivotal. Generally speaking, cold rolling is difficult to produce high-quality C-beam, so it needs to be completed by C-beam mill.
After the material enters from the tail of the C-beam machine, it is pressed down by various rollers, and the formed C-beam is exported from the machine head. This not only greatly optimizes the necessary production and processing technology, but also improves the output. It can also ensure the average wall thickness and complex interface shape of C-beam products.
In order to achieve the correct wall thickness, the die used by the C-beam machine consists of the correct upper die and some lower dies with the same size, specification and size. In order to install them in place before processing, it is necessary not only to ensure the smooth operation of the upper and lower dies, but also to ensure that the adjacent gaps are even so that the pressed C-shaped steel can have an average wall thickness.
In the process of processing C-section steel, the mould is installed and the main engine is tested. Then start the air compressor, vacuum pump, extruder, brick cutter, feeder, brick press, host and tile conveyor. When parking, first stop the extruder and then rest of the equipment.
Before using the equipment, we should check whether the connection is firm, whether the mounting bolts and nuts are tightened, and add enough lubricating oil to the left and right chassis before starting the engine with electricity. The slurry extruded from the extruder is cut into a fixed length by the cutter, transported to the brick press by the roller conveyor, and transported to the lower die by the loader according to the specified procedure. After dividing the brick blank pressed by C-beam machine on the worktable, it is absorbed by the vacuum suction cup of the brick unloader, and is placed on the brick blank support of the conveying line after graduation.
The wall thickness of C-section steel made by this machine can be made very thin, which greatly simplifies the production process and improves the production efficiency. It can produce all kinds of profiles with uniform wall thickness but complex cross-section and cold-formed color steel equipment of different materials, which are difficult to produce by ordinary hot rolling method.
The above is about how to control the thick wall quality of C-section steel. I hope you can help after reading. If you want to know more about Jinan C-section steel, please pay attention to our website.