熱門關鍵詞：濟南彩鋼板 | 濟南復合板 | 濟南彩鋼瓦 | 濟南c型鋼 | 濟南鋼結構 |
Different users have different requirements for section steel wall thickness. If we want to meet these requirements at the same time, the production process and equipment of Jinan C-steel plant is very important. In general, it is difficult to produce high quality C-section steel by cold rolling, so C-section mill is used to complete.
After the material enters from the tail of C-shaped steel, it is pressed down by various rollers, and the head outputs the special-shaped C-beam. This not only greatly optimizes the necessary production process, but also increases the output. The uniform wall thickness and complex interface shape of C-steel products are ensured.
In order to achieve accurate wall thickness, the mold used in the C-beam press consists of accurate upper mold and some lower mold of the same size, specification and size. In order to be installed in place before processing, it is necessary to ensure not only the smooth operation of the upper and lower dies, but also the uniform gap around the upper and lower dies, so that the pressed C-section steel has a uniform wall thickness.
In the process of processing C-section steel, the installation of the die and the debugging of the main machine are carried out. Then start the air compressor, vacuum pump, extruder, brick cutter, feeder, brick press, main machine and tile conveyor. When stopping, stop the extruder first and then the rest of the equipment.
Before using the equipment, we should check whether the connection is firm, whether the mounting bolts and nuts are tightened, and add enough lubricating oil to the left and right chassis before starting the engine electric test. The slurry of the extruder is cut into fixed length by the cutter, transported to the brick press by the roller conveyor, and then transported to the lower die by the loader according to the specified procedure. After the C-steel blank is divided on the workbench, it is absorbed by the vacuum suction cup of the brick unloader. After graduation, it is placed on the blank bracket of the conveyor line.
The thickness of the C-beam made by the mechanism can be very thin, which greatly simplifies the production process and improves the production efficiency. It can produce all kinds of cold-formed color steel equipment with average wall thickness, complex sections and different materials which are difficult to be produced by common hot rolling method.
The above is the relevant content introduced by the small edition of Jinan C steel works. If you want to know more, please visit the website: http://www.cheholam.com